48 Series Flat Belts

48FB Series Center Drive Flat Belt Conveyors

48FB Series Center Drive Small Motor

48FB Series Center Drive Large Motor

48FB Series Center Drive Flat Belt

Specifications:

 

  • Frame Height: 51mm (2”)
  • Widths: 48mm—650mm (1.8” - 25.6”)
  • Lengths:  610mm — 12192mm  (2 - 40 ft)
  • Speeds: Up to 400 FPM
  • Loads Up to 200 lbs
  • Sealed Bearings
  • Stainless Steel Slider Bed
  • 18mm Diameter Drive Shaft
  • Metric Fasteners
  • Welded Endless Belts
  • Variable  or Fixed Speed
  • Optional  “V” Guides Belts
  • Optional 12mm Transfer Nose both Entrance and Exit End
  • Optional Multiple Lane with Single Drive

Features:

 

  • Low Profile
  • Higher Load Capacities
  • Drive Can be Moved up and Down the Conveyor
  • Center Drive Leaves Entrance and Exit Unobstructed
  • Belt is the Highest Point Allows you to Pass Part Wider  than the Conveyor
  • Heavy Wall Extrusion
  • Fully Assembled Ready to Install
  • Dual “T” Slots (8.1mm) for More Mounting Area
  • Longer Bearing Holders for More Take Up
  • Bright Anodized Extrusion

 

Sign Up and Configure

Configure Now

48FB Series Center Drive Flat Belt Small Motor Inline

48FB Series Center Drive Flat Belt Large Motor Inline

48FB Series Center Drive Flat Belt Large Motor Right Angle

 

48FBSeries Clamp Bearing used on 400mm Frames an Wider

10mm Nose Bar 48FB Series Flat Belt Conveyor

 

 

Standard Sizes (48FB Series Center Drive)

Note:

FW (Frame Width - 15mm (.590”) = BW (Belt Width)

OAL (Overall Length) = Conveyor Tip to Tip

Frame Widths over 400mm Require “V” Guided Belts

Clamp Style Bearing are Used on Widths over 400mm and High Speed Applications

Transfer Nose Bars on Idler Ends Only

Transfer Nose Bars on Conveyor Speeds Less Than 75 Feet Per Minute

 

 

 

 

 

Need More Information?

Submit